Setup a New Device
Prerequisites:
l The touch panel must be enabled. Refer to the (Start > Settings > Options > Misc) Touch Panel Disabled setting. If the
Touch Panel Disabled option is dimmed, the touch panel cannot be turned off by the user.
l An MX9 default input method (Input Panel, Transcriber, or custom input method) is assigned.
Devices with AppLock are shipped to boot in Administration mode with no default password, thus when the device is first
booted, the user has full access to the MX9 and no password prompt is displayed. After the administrator specifies
applications to lock, a password is assigned and the device is rebooted or the hotkey is pressed, the MX9 switches to end-user
mode.
The process to configure a new device is as follows:
1. Insert a fully charged battery and press the Power button.
2. Connect an external power source to the device (if required).
3. Adjust screen display, audio volume and other parameters if desired. Install accessories (e.g., handstrap,
stylus).
4. Tap Start > Settings > System > Administration icon.
5. Assign a Switch Key (hotkey) sequence for AppLock. See Security Panel.
6. Assign an application on the Application tab screen. More than one application can be assigned.
7. Assign a password on the Security tab screen.
8. Select a view level on the Status Panel screen, if desired.
9. Tap OK.
10. Press the Switch Key sequence to launch AppLock and lock the configured application(s).
The device is now in end-user mode.
4-49
To Next Page
Loading...
