Honeywell MX9 - Page 223

UPCE0
Note: The UPCE0 and UPCE1 parameters are always set to match each
other. Therefore if a change is made to a parameter to either the
EPCE0 or UPCE1 Advanced Properties that same change is
automatically made to the Advanced Properties for the other
symbology.
Note: UPCE0 and UPCE1 are enabled as the same symbology at the
scanner. Therefore, the only way for UPCE1 configuration to be used
is if UPCE0 is disabled. When UPCE0 is disabled, it is scanned by
the imager but rejected by Data Collection Wedge.
Transmit Check Character – When enabled, transmit the check character.
Default is enabled
Transmit number System Digit – When enabled, transmit the number system
digit. Default is enabled.
Expand Version E – When enabled, expand version E to 12-digit UPCA
format. Default is disabled.
Addenda
Read 2-Digit – When enabled, transmit the 2 digit addenda. Default is
disabled.
Read 5-Digit – When enable, transmit the 5 digit addenda. Default is disabled.
Required – When enabled, only transmit bar codes with a 2 or 5 digit addenda.
Default is enabled.
Insert Separator – When enabled, insert a space between the code and
addenda. Default is disabled.
UPCE1
6-27