RAEGuard 3 User Manual
42
11 Faults and Warnings
The table below provides details of possible error.
Check terminal plate, safety barrier
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change
Replace the sensor module supported by
RAEGuard 3.
Check sensor modules, or change
Catalytic bead
sensor calibration
failure
Please recalibrate, or check whether the
calibration operates in accordance with the
process, or replace the sensor
4-20 mA current loop
abnormalities
Check main board or sensor module, or
replace them
Terminal/power
board failure
Check terminal / power board, or replace
them
Terminal/power
board failure
Check terminal / power board, or replace
them
Check sensor modules, or change
Check sensor modules, or change
Check sensor modules, or change, or
contact the factory
Check sensor modules, or change, or
contact the factory
Communication
failure between
sensor and
transmitter
Check the cable and safety barrier, re-
energize the detector or replace the barrier,
or contact the factory.
To Next Page
Loading...
