Honeywell SMV800 - Page 24

Page 12 SMV800 Modbus User's Guide Revision 1.0
Refer to the below table for Device Information:
Key: Plain = Read only Bold = Configurable
Bold underline = Method Bold italic = Table or
graph
Manufacturer
Honeywell
Device Model
Displays Model or Device Type of SMV800
Transmitter
Device Revision
Displays Field Device Revision of the SMV800
Transmitter
Software Rev
Software revision
Pressure FW Rev
Pressure Sensor Board Firmware Version
Temperature FW Rev
Temperature Sensor Board Firmware Version
Display FW Rev
Display Board Firmware Version
Communication FW Rev
Communication board Firmware Version
Model Number
Displays the model number of the device
Long Tag
Enter Tag ID name up to 32 characters
Date
Gregorian calendar date that is stored in the Field
Device. This date can be used by the user in any
way.
Tag
Enter Tag ID name up to 8 characters
Write Protect
Indicates the current state of the device write protect
option as enabled (yes) or disabled (no)
Transmitter Install Date
(One time editable) Transmitter installation date in
MM/DD/YYYY format.
Note : If install date is not present then it will show
default install date as 01/01/1978
Temp Module Install Date
(One time editable) Temperature Module installation
date in MM/DD/YYYY format.
Note: If install date is not present then it will show
default install date as 01/01/1978
Final Assembly Number
Used for identifying electronic components. This
number can be used by the user in any way.
Serial Number
Shows serial number of the device.
Message
Enter a message up to 32 alphanumeric
characters) that will be sent to the Display. The
message will be shown on the Display
interspersed with the configured screens.
Clear Message
Select to clear message from transmitter’s local
display.