Honeywell SMV800 - 2.3.2. Local Display

Revision 1.0 SMV800 Modbus User's Guide Page 13
2.3.2. Local Display:
This tab provides the detail information about the local display.
Refer the below table for Local Display Configuration:
Local display parameters
Display Setup Parameters
Key: Plain = Read only Bold = Configurable Bold underline = Method Bold italic = Table or graph
Display Connected
Identifies whether a Display is
connected to the
device
Display Type
Identifies the type of Display connected
to the
device (only Advanced Display is
available for
SMV devices)
Language Package
Identifies the language package
selected as Eastern or Western
Common Setup
Language
Select the desired language to be used
for the Display.
Rotation Time
Select the desired time delay for
switching between configured screens
(3 to 30 seconds)
Screen Rotation
Select to enable or disable screen
rotation.
Contrast Level
Select the level of contrast for the
Display (default = 5, or select levels
1(low) to 9 (high))