Honeywell SMV800 - Page 26

Page 14 SMV800 Modbus User's Guide Revision 1.0
Screen Configuration
Configure Screen
Select the screen to be configured:
Screen 1 to 8
Select the screen format:
None
PV
PV & bar graph
PV & trend
Enter high and low limits for trend or ba
rgraph, if
PV & trend or PV & bar graph were
selected for
screen format
Enter trend duration from 1 to 24 hours if
PV &
trend was selected for screen format
Enter the PV selected for this screen:
Differential Pressure
Static Pressure
Process Temperature
Flow
Meter Body Temperature
Sensor Resistance
 Totalizer
User Variable 1 to 8
Enter the selection for PV scaling
(note: available selections are dependent
on PV
selection):
None
Convert Units
Linear (for custom units)
Enter the high and low scaling values if
Linear PV scaling was selected.
Select the new engineering unit if Convert
Units
PV Scaling was selected.
Select number of decimal places desired
for the
PV selected (1,2, or 3 decimal places)
Enter a custom tag for the display screen
up to 14
characters if desired. If no custom tag is
entered,
a default tag consistent with the PV
selection will be used.