Honeywell SMV800 - Page 53

Revision 1.0 SMV800 Modbus User's Guide Page 41
Primary Element
Standard V-Cone with ASME method
Wafer Cone with Macrometer method
Wafer Cone with ASME method
Wedge
Integral Orifice
When Algorithm Options =
Advanced Algorithms
Orifice Flange Taps D >/= 2.3 inches
Orifice Flange Taps 2 </= D </= 2.3
Orifice Corner Taps
Orifice D and D/2 Taps
Orifice 2.5 and 8D Taps
Venturi Machined Inlet
Venturi Rough Cast Inlet
Venturi Rough Welded Sheet-Iron Inlet
Leopold Venturi
Gerand Venturi
Universal Venturi Tube
Low-Loss Venturi Tube
Nozzle Long radius
Nozzle Venturi
Preso Elipse Ave. Pitot Tube
Other (Std compensation mode) Pitot Tube
When Algorithm Options =
SMV3000 /ASME 1989 with
Dynamic Corrections or
Standard
Flow Calc Standard
ASME-MFC-3M
ISO5167
GOST
AGA3
VCONE/WAFER CONE
ASME-MFC-14M
WEDGE
AVERAGE PITOT TUBE
INTEGRAL ORIFICE
CONDITIONAL ORIFICE
CONDITIONAL ORIFICE
When Algorithm Options =
Advanced Algorithms
Automatically set based on
Primary Element type and
Primary Element
ASME 1989
When Algorithm Options =
SMV3000