Honeywell SPZ-8000 - VOR DIRECT to Function; 10 VOR DIRECT to Function

SPZ--8000 Digital Integrated Flight Control System
A28--1146--055
REV 2
Modes of Operation
8-12
VOR DIRECT TO Function
Another option is to fly a VOR intercept that has a zero deviation to the
VOR station. This procedure is described in Table 8--2.
Step
Procedure
1 Establish the VOR intercept as previously described.
2 Set the bearing selector to the same NAV source that is
being used for the VOR intercept on the display controller.
3 The EHSI displays as follows:
The course pointer displays the pilot selected course to
the VOR station
The bearing pointer displays a zero deviation course to
the VOR station.
4 To fly the zero deviation course to the station, push the
PUSH DCT button on the instrument remote controller
CRS knob. The course select pointer aligns with the
bearing pointer and sets a zero deviation course to the
VOR station, as shown in Figure 8--10.
NOTE: Pushing the PUSH DCT button while engaged in VOR mode,
cancels the mode if the course change is greater than 3.
VOR DIRECT TO Function Procedure
Table 8- -2