SPZ--8000 Digital Integrated Flight Control System
A28--1146--055
REV 2
Multifunction Display (MFD) System
5-16
Changing a Waypoint
When the MFD is operating with the FMS, waypoints can be added,
deleted, or moved, as described in Table 5--1. The procedure adds a
waypoint between IRW and PER (IRW/056/47.1).
Step
Procedure
1 Using the SKP button on the MFD controller, move the
designator from ADM (the TO waypoint) to IRW. Then
using the joystick, move the designator to where the new
waypoint is to be located, as shown in Figure 5--12. The
distance/bearing of the designator is always shown in the
upper left corner of the MFD.
AD--58096@
33. 3
4:39
0.5L
SRP
Changing a Waypoint
Figure 5--12
2 Use the ENT button on the MFD controller to send the
designator position to the FMS control display unit.
NOTE: It is usually easier to use the MFD MAP mode to define or change
a waypoint.
Changing a Waypoint Procedure
Table 5--1 (cont)
To Next Page
Loading...
