18 Thor VM1A Vehicle-Mounted Computer
• To set the brightness level manually, verify the Adaptive brightness feature
is turned Off, and tap Brightness Level. Adjust the slider to set the
brightness level.
To set the brightness level manually, verify the Adaptive brightness feature is
turned off, and tap Brightness level.
•Use the Blue Key + F7 keypress to increase backlight brightness.
•Use the Blue Key + F8 keypress to decrease backlight brightness.
Screen Blanking
Screen blanking (blackout) can be enabled when the vehicle is in motion. Once
screen blanking is enabled, the display is blanked out (or a preselected zoom area
is displayed) any time when the vehicle is in motion. If the screen blanking cable is
removed, screen blanking is disabled and the display remains On.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Settings > Honeywell Settings > Zoomzone.
Motion Detection Action
Determine what to do when motion is detected:
• Display Always Active - The display does not change when motion is detected.
• Display Black - The display is blacked out when motion is detected.
• Display Freeze - The display is frozen at the time motion is detected.
• Zoom Zone - A preconfigured zoom area is displayed when motion is detected.
Motion Timeout Settings
Screen blanking can be configured to provide delays.
• Delay on Motion - Configure the delay between motion detection and screen
blanking. The default is 2 seconds.
• Delay on Stop - Configure the delay between motion stopping and the screen
resuming normal behavior. The default is 2 seconds.
Motion Detection Source
Select the Motion Detection Source. The computer supports the screen blanking
box to determine motion.
Select the port (COM1 or COM2) the blanking box is attached.
To Next Page
Loading...
Need help?
General
