Thor VM1A Vehicle-Mounted Computer 27
Insert an SD Card
You can use an SD card to increase file storage capacity or to install software. Hon-
eywell recommends the use of Single Level Cell (SLC) industrial grade SD or SDHC
memory cards with the computer for maximum performance and durability.
Note: Format the memory card before initial use.
Equipment Required
The following equipment is user-supplied:
• Torque tool capable of measuring inch pounds
• SD card up to 512 GB
• #2 Phillips screwdriver bit
Installation Procedure
1. For convenience, the computer can be removed from the dock, though it is not
necessary. If the computer remains in the dock, disconnect the power cable
from the dock.
2. Press and hold the Power button until the options menu appears. Tap Power
Off.
3. If the computer was removed from the dock, place the computer face down on a
stable surface.
4. Using a #2 Phillips bit loosen the M3 screws and then remove the access panel
with the SD label. This panel is on the left hand side when the computer is face
down with the top away from the user.
Defroster enabled
temperature
Set the temperature (°C) that the computer must fall to before the
system determines cold storage entry and defroster use.
Defroster State Shows current state of defroster, On or Off.
Temperature Shows detected LCD window temperature
Manual/Automatic Tap the button to switch between Automatic mode or Manual
mode. To learn more about the modes, see
How Automatic Mode
Works
on page 25 and Manual mode on page 26.
Defroster On/Off Tap the button to switch between On and Off.
Defroster Setting Description
To Next Page
Loading...
Need help?
General
