TR50 - User Guide 49
Fixed Values: The values will be directly returned to the TR50 for calculation.
Linkable Values: The controller value will be linked to the linkable Parameter, so
that dynamically based on current logical condition the user can change the low
limit and high limit values.
Step 3. After configuring the alarm limits, the alarm value will be detected in the
TR50.
Step 4. From the Palette drag-drop the Sensor Alarm to the wire sheet and click
OK.
Step 5. Below Sensor Alarm Parameter shows the value coming from the TR50
into the controller.
By using the sensor alarm parameter user can know the alarm status in the TR50
device.
To Next Page
Loading...
