TR50 - User Guide 53
Follow the below steps to do linkage and monitor sensor failure:
Step 1. From the Palette, Drag and drop the Sensor Failure into the wire sheet.
Step 2. From the Palette, add a CO
2
Parameter and click OK.
Step 3. Copy the CO
2
parameter property and paste in the Sylk parameter under
sensor failure, click Save.
Note: Make sure the sylk device is same in the sensor failure as per the parameter.
When there is a physical failure in the CO
2
sensor, this sensor failure functional
block will report the state in the application.
To Next Page
Loading...
