MAN1032-10-EN_EXL6_UserManual
March 12, 2020 81 | 191
8.7 Analog Inputs
NOTE: See the data sheet for the EXL6 OCS model being used for jumper settings. Refer to the
Cscape Configuration chapter for more details.
The analog inputs on the EXL6 OCS allow voltage or current measurement from a variety of
devices. The voltage or current mode is set though jumpers on the unit and settings in Cscape.
Each channel can be separately configured for voltage or current mode.
The analog inputs have a digital filter that can be used to filter electrical noise that may be
unavoidable in some installations. The downside to digital filtering is the inputs will respond
more slowly to sudden changes in the actual input.
8.8 Universal Analog Inputs Model 5
NOTE: See the data sheet for the EXL6 OCS model being used for jumper settings and see the
appropriate pages in this manual (see Index) for details on how to use Cscape to configure the
digital filtering.
The universal analog inputs provide a high resolution, very flexible interface for a variety of
analog inputs. These inputs include voltage, current, thermocouple, RTD, and millivolt. Each
channel can be configured separately using jumpers and configuration settings in Cscape.
Like the standard analog inputs, these inputs have a digital filter that can be used to filter
electrical noise that may be unavoidable in some installations. The downside to digital filtering
is the inputs will respond more slowly to sudden changes in the actual input.
To Next Page
