3
SAFETY INSTRUCTIONS
General
Installation & maintenance should only be carried out by
competent persons accredited by Horton Automatics Ltd, for whom
this manual is intended.
For personal and user safety carefully read and follow the
instructions within this manual.
Installation & commissioning must be carried out in accordance
with EN 16005, BS 7036:0 force and following good practice.
Use only genuine manufacturer approved parts.
Retain these instructions for future reference.
Pay careful attention to messages marked with hazard symbols.
They warn of potential equipment damage or personal injury.
Before Installation
Secure entrance from pedestrian traffic.
Ensure mains power supply is safety isolated prior to connection.
Check the product is complete and free from damaged.
Determine that fixing locations are sufficiently true & load bearing.
Check risk assessment is accurate to location and site conditions,
report any anomalies and liaise with project manager.
Whenever residual risks observed at doorset installation are too
great for application or intended safeguarding measures are not yet
installed or operational do not put system into powered operation,
isolate it from power and consult with project manager.
On Completion
Ensure logbook is present and complete. Retain these instructions and issue
user manual and commissioning checklist to client representative.
To Next Page
Loading...