7
OWNER RESPONSIBILITIES
To ensure continued operation of a powered door installation, the
installation and its environment should be subjected to systematic
operational checks as often as is appropriate to the type of installation and
its traffic flow. This should be assessed with reference to the Hazard Analysis
and Risk Assessment carried out e.g. in high traffic areas such as shops,
hospitals and airports, an appropriate rate would be at least once a week.
According to The Workplace Regulations 1992 and Provision & Use of Work
Equipment Regulations 1998, as a building owner / occupier it is a
responsibility to regularly inspect automatic pedestrian door systems to
safeguard the health and safety of employees and other persons.
Safety Checks
Should a doorset fail to operate as prescribed in the following checks, or at
any other time for any other reason, do not attempt to repair or adjust the
door. Call an ADSA accredited engineer trained to service Horton operators
in accordance with mandatory and regulatory safety standards.
Visual Inspection
• Identify and remove any distractions or obstructions in vicinity of door
which may lead to congestion.
• Flooring in and around doorway should be clear and free of tripping
and slip hazards at all times.
• Ensure warning and information signage is clearly displayed
• Check security and condition of glazing, frames and barriers for hazards
caused by damage.
Automatic Activation
Verify automatic activation sensor operation by towards doorway and into
sensor activation zone. The door should open smoothly and stop without
impact. Once clear of the doorway and after a time delay the door should
close smoothly. For two way doors repeat check in both directions.
Manual Activation
Manual activation devices such as push switches, card-readers, key switches
etc. should be tested by activation of each device in turn. The door should
open smoothly and reclose after a time delay.
To Next Page
Loading...