For
HP
Internal Use
Only
Value Assembly
0
No
failing FRU
1 Controller
PCA
2 Mechanism
SKSV (Sense Key Specific Valid). Set
to
1
if
the
Sense Key specific bytes (bytes
15
through
17) are valid. These bytes are valid only when
they
assume
the
role
of
Field
Pointer
bytes.
This will occur when
an
illegal Field Check detects
an
error
in
a
command
parameter
list.
If
this
bit
is
not
set,
the
CD,
BPV,
and
Bit
Pointer
fields will
be
set
to
0,
the
top
byte
of
the
Field
Pointer
field will
be
0,
and
the
bottom
byte
of
the
Field
Pointer
field will contain a
product-specific
error
code.
CjD.
If
set,
the
Field
Pointer
information applies
to
the
command
descriptor block.
If
not
set,
the
Field Pointer information applies
to
the
parameter
list for
the
command
(Only valid
if
SKSV is set.)
BPV.
Indicates
the
Bit Pointer field is valid. Set
if
SKSV is set.
Bit
Pointer.
Identifies
the
bit
position
of
the
field
in
error. (Only valid
if
SKSV is set.)
Field
Pointer
/Drive
Error
Code. This field is dependent on
the
SKSV field as follows:
If
SKSV is set
to
1, this field identifies which
byte
of
the
command
descriptor
/parameter
list
an
error was detected in. If SKSV is set
to
0,
the
top
byte
of
this
field contains
the
drive
error
code associated
with
the
failure
of
the
previous command,
or
it
contains zero
in
the
case
of
no
failure/no
appropriate
error
code ( refer
to
Table 5-56 for a list
of
drive
error
codes).
Copy Target
Status.
Returned
only
if
the
Sense Key is Copy
Aborted.
Set
to
the
value of
the
status
byte
returned
to
the
drive from a Copy Target which resulted
in
the
failure
of
the
last
Copy operation.
Copy Target
Sense.
Returned
only
if
the
Sense Key is Copy
Aborted.
Contains
the
Sense
data
returned
to
the
drive by
the
last
copy
target
the
drive communicated with.
The
drive
would have requested this
data
by issuing a
REQUEST
SENSE
command
to
the
copy
target
in response
to
receiving a non-good
status
from
the
copy
target.
Troubleshooting 5-69
To Next Page
Loading...
Need help?
General