For
HP
Internal Use Only
8mm
Tape
Drive
(A3024A) Configuration
The
location
of
the
address
jumpers
on
the
8
mm
tape
drive is shown
in
(xref fig12gsa>. Set
the
address
to
one
of
the
valid addresses, shown
in
Figure 4-18. Address 7 is reserved
and
can
not
be used as a device address.
Grounding
Hole
Ground
Tab
Pin
SCSI
Address
Jumpers
Power
Resistor
Terminators
Figure 4-17.
Smm
Tape Drive (A3024A) Configuration
0
2
3
4
5
Figure 4-18.
Smm
Tape Drive (A3024A) Address Jumper Settings
Floppy
Disk
Drive
Configuration
The
jumpers
for configuring
the
floppy disk drive are shown
in
Figure 4-19.
Refer
to
Table 4-23.
The
SCSI ID address
of
the
drive should always
be
set
to
3.
Note A logical 1 is indicated by
the
absence of a
jumper.
6
WBCE046
Jumpers
must
always
be
on
H,
Hl.
and
H2. This sets
the
floppy disk density
to
2 MB.
Jumpers
must always
be
on HDS,
and
PAR.
Configuration 4-45
To Next Page
Loading...
Need help?
General