For
HP
Internal Use Only
Remove 3.5-inch Digital Data Storage (DDS) Device
1.
See Figure 8-5.
2.
Disconnect
the
SCSI flat ribbon cable from the DDS.
3.
Disconnect
the
power cable from the DDS.
4. See Figure 8-6.
5. Remove four
TORX
screws and remove
the
DDS from
the
front of
the
peripheral drawer.
Warning
Do not mix these screws
with
the system chassis screws or the disk support
screws.
You
will
damage the DDS if you attempt to mount it
with
the system
chassis screws or the disk support screws.
8-14
Replaceable Parts
To Next Page
Loading...
