HP 3000 Series - Remove 8 Mm Tape Drive

For HP Internal Use Only
Remove 8mm Tape Drive
1. See Figure 8-11.
2. Disconnect the SCSI fiat ribbon cable from the 8mm tape drive.
3. Disconnect the power connector from the 8mm tape drive.
4. See Figure 8-12.
5. Remove four TORX screws and remove the 8mm tape drive from the front of the
peripheral drawer.
Warning
Do not mix these screws with the system chassis screws. You will damage the
Bmm tape drive if you attempt to mount it with the system chassis screws.
Replaceable Parts 8-23