For
HP
Internal Use Only
Remove Internal 3.5-inch Disks
1.
See
Figure 8-14.
2.
Disconnect the SCSI flat ribbon cable from each disk
3.
Disconnect
the
power connectors from each disk.
4. Remove eight
TORX
screws
and
remove the two disks from
the
disk carrier.
Warning
Do not mix these screws
with
the system chassis screws or the DDS support
screws.
You
will
damage the disk if you attempt to mount it with the system
chassis screws or the DDS support screws.
Replaceable Parts 8-27
To Next Page
Loading...
