3-191
Performance Tests
ETSI/ANSI Receiver Equalization (Option UKZ)
4. Connect Cable Simulator #5 (see Recommended Test Equipment Table in
Chapter 1) between the HP 37717C Transmitter Output and Receiver Input ports.
5. Press RESULTS [TROUBLE SCAN] , then RUN/STOP key to start the
measurement.
6. Ensure that NO TROUBLE is displayed on the RESULTS page after 30 seconds.
7. Press RUN/STOP key to stop the measurement.
34.368 Mb/s Equalization
1. Select the HP 37717C TRANSMIT
page, select PHYSICAL LAYER and set
as follows;
2. Connect Cable Simulator #6 (see “Recommended Test Equipment” in Chapter 1
on Page 67) between the HP 37717C Transmitter Output and Receiver Input ports.
3. Press RESULTS [TROUBLE SCAN] , then RUN/STOP key to start the
measurement.
4. Ensure that NO TROUBLE is displayed on the RESULTS page after 30 seconds.
5. Press RUN/STOP key to stop the measurement.
To Next Page
Loading...
Need help?
General
