HP 37717C Calibration Manual

B-2
Appendix B - Fitting/Calibrating/Testing New Modules
* 37717-60020/21 may be used (Structured PDH Modules). ** 37714-60012/
60013 may be used (STM1/4 Modules).
CAUTION If 37714-60012 (Option URU) is fitted, the optical output must be attenuated by 10
dB before connecting to the Optical input of any other 37717C optical module.
Failure to do this could result in damage to the HP 37717C. Table 3-1 lists a suitable
attenuator.
STM-1 Electrical Jitter
Receiver
A1M,
[A1Q] A3L
[A3M]
Jitter Tx PDH
Tx/Rx SDH Tx/
Rx
37717-60010
37714-60044*
37714-60048
Jitter Tx
STM-1 Optical Jitter Rx A1N, [A1R]
A3V [A3W]
Jitter Tx PDH
Tx/Rx SDH Tx/
RxS TM-1 Optic
Tx
37717-60010
37714-60044*
37714-60048
37714-60011**
Jitter Tx
STM-1/4 Optical Jitter
Receiver
A1P, [A1S]
A3N [A3P
Jitter Tx PDH
Tx/Rx SDH Tx/
Rx STM1/4
Optic Tx
37717-60010
37714-60044*
37714-60048
37714-60013**
Jitter Tx
Additional PDH Outputs UHC, [US6] PDH Tx/Rx 37714-60044* No
Table B-1 Additional Modules Required for Performance Tests
Module Under Test Option
Under Test
Module(s)
Required
Part Number Calibration
Required?

HP 37717C Specifications

General

Brand	HP
Model	37717C
Category	Measuring Instruments
Language	English