Console switch serial management 75
4.
To specify an IPv4 or IPv6 IP address, select Option 2—IP Configuration. Use a static IP address for
ease of configuration. If you are using a BootP address, configure the BootP server to provide an IP
address to the console switch, and then continue to step 7.
5. If you are using a static IPv4 address, perform the following steps:
a. To specify an IP address, select Option 3—IP Address.
b. To specify a netmask, select Option 4—Netmask.
c. To specify a default gateway, select Option 5—Default Gateway.
To Next Page
Loading...
