100
Figure 34 Patches that are not loaded to the patch memory area
DEACTIVE state
Patches in DEACTIVE state have been loaded to the patch memory area but have not yet run in the system.
For example, suppose that the patch file you are loading has seven patches. After the seven patches
successfully pass the version check and CRC check, they are loaded to the patch memory area and are
in DEACTIVE state. In the patch area, patch states are as shown in Figure 35.
Figure 35 Patch states in the patch memory area after a patch file is loaded
ACTIVE state
Patches in ACTIVE state run temporarily in the system and become DEACTIVE at a reboot. For the seven
patches in Figure 35, if y
ou activate the first five patches, their states change from DEACTIVE to ACTIVE.
The patch states in the system are as shown in Figure 36.
T
he patches that are in ACTIVE state are in DEACTIVE state after system reboot.
To Next Page
Loading...
Need help?
General
