HP 8590 E-Series - Common Preset Conditions

‘Ihble 7-11. Common Preset Conditions
A-B-A
Amplitude correction factors
Amplitude units
Annotation and graticule display
Attenuation
Center frequency
CF step size
Coupled functions
Coupling *
Mass storage device (card or internal)
Detector
Display line level
Frequency offset
Limit-line testing
LIMIHI and LIMILO
Log scale
Marker counter t
Marker counter resolution t
Markers
Mixer level
Operating mode
Preselector peak $
Reference level
Reference level offset
Reference level position
Resolution bandwidth
Span
3RQ mask
Start Frequency
Stop Frequency
State registers l-8
Sweep
fhreshold level
fitle
l’race A
frace B
frace C
rrace registers
ri-igger
VBWIRBW ratio
Video averaging
Video bandwidth
Off
Off
default values
on
10 dB (auto-coupled)
Refer to Table 7-10.
10% of span
all set to AUTO
AC
INTERNAL
positive peak
2.5 graticule divisions below reference level, display off
0 Hz
Off
cleared
10 d B/division
Off
auto-coupled
Off
-10 dBm
spectrum analyzer
reset
0 dBm in power-on units
D dB
top (8th) graticule
3 MHz (auto-coupled)
Refer to Table 7-10.
actal 50
Refer to Table 7-10.
Refer to Table 7-10.
unaffected
continuous
lne graticule above baseline, display off
cleared
clear-write
store-blank
store-blank, at reference level
maffected
‘ree run
1.3
lff
1 MHz (auto-coupled)
L HP 85943, HP 85953, or HP 85963
only.
1 All E-Series and L-Series spectrum analyzers except HP 85901, with Option 713
: HP 8592L. HP 85933. HP
85953. or HP 85963 onlv.
Key Descriptions 7-67