11-6 ES User’s Guide
Factory Preset State and Memory Allocation
Factory Preset and Peripheral States
CONFIGURE Key Settings (continued)
1. 75 ohms if your analyzer is Option 1EC (75 ohm test ports)
2. See “Peripheral State” on page 11-8 for analyzers with Option 100.
Limit fail icon On
Limit pass/fail indicator "X" position 80%
Limit pass/fail indicator "Y" position 60%
Marker limits Off
Limit test Off
Previously set limits Deleted
Active calibration Last active cal if valid;
otherwise, default cal
Detector zero Autozero
Cal kit Type-N female
System Z
0
50 ohms
1
Velocity factor
2
1.0 (speed of light)
Smith chart Z
0
50 ohms
1
Port extensions Off
Refl port extensions 0 s
Trans port extensions 0 s
On/off All off
Delta marker state Off
Search Off
Bandwidth search level −3
CAL
MARKER
To Next Page
Loading...
