HP 9000 Series Instruction Manual

Chapter 1 31
Installing and Configuring 10/100Base-TX/9000
Step 6: Configure the 10/100Base-TX Link
address and the Internet broadcast address. Activate the SAM
online help for additional information on these options.
7. Activate the OK button at the Configure LAN Card window to enable
your 10/100Base-TX card.
If the software is correctly configured, SAM displays the Network
Card Configuration object list with the status Enabled for your
10/100Base-TX card; otherwise, SAM displays an error message.
8. At the Network Card Configuration menu, choose Exit from the “File
menu.”
If you have moved or removed any 10/100Base-TX cards from the
system, HP recommends that you verify the IP/Internet address of
every card in the backplane before leaving SAM
9. Use lanscan to check the network interface and the hardware state of
the 10/100Base-TX card.
NOTE For HP 9000 HP-PB systems, the hardware path is in the format, a/b.
For 10/100Base-TX/9000, a is the address of the optional bus converter,
and b is the slot number where the card is installed. To determine the
hardware path of an HP-PB LAN card, multiply the system bus slot
number by 4. For example 10/4 specifies that the HP-PB card is located
in bus converter 10, slot number 1.
Download from Www.Somanuals.com. All Manuals Search And Download.

HP 9000 Series Specifications

General

Operating System	HP-UX
Manufacturer	Hewlett-Packard (HP)
Series	9000
Type	Server
Processor	PA-RISC
Memory	Varies by model
CPU	PA-RISC processors
Expansion Slots	Varies by model
Networking	Ethernet
Form Factor	Rackmount
Models	A-Class, D-Class, E-Class, K-Class, N-Class, RP Series, Superdome