HP A5120 EI Series User Manual

94
Table 18 Output description
Field
Description
Ethernet1/1 BOOTP client information or Vlan-
interface1 BOOTP client information
Information of the interface serving as a BOOTP client
Allocated IP
IP address assigned to the BOOTP client
Transaction ID
Value of the XID field in a BOOTP message, which is a
random number chosen when the BOOTP client sends a
BOOTP request to the BOOTP server. It is used to match a
response message from the BOOTP server. If the values of
the XID field are different in the BOOTP response and
request, the BOOTP client will drop the BOOTP response.
Mac Address
MAC address of a BOOTP client
ip address bootp-alloc
Syntax
ip address bootp-alloc
undo ip address bootp-alloc
View
Interface view
Default level
2: System level
Parameters
None
Description
Use the ip address bootp-alloc command to enable an interface to obtain an IP address through BOOTP.
Use the undo ip address bootp-alloc command to disable the interface from obtaining an IP address
through BOOTP.
By default, an interface does not obtain an IP address through BOOTP.
Related commands: display bootp client.
Examples
# Configure VLAN-interface 1 to obtain IP address through the BOOTP protocol.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ip address bootp-alloc

HP A5120 EI Series Specifications

General

Uplink Ports	4 x SFP
Stacking	No
Management	CLI, Web, SNMP
Routing Protocols	RIP, OSPF
Power Supply	AC
MAC Address Table Size	16K
Dimensions	440 x 430 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% non-condensing
Model	HP A5120-24G EI Switch (JG234A)
VLANs	4094