111
<Sysname> display fib 10.2.1.1
Destination count: 1 FIB entry count: 1
Flag:
U:Useable G:Gateway H:Host B:Blackhole D:Dynamic S:Static
R:Relay
Destination/Mask Nexthop Flag OutInterface InnerLabel Token
10.2.1.1/32 127.0.0.1 UH InLoop0 Null Invalid
For description about the output, see Table 25.
display icmp statistics
Syntax
display icmp statistics [ slot slot-number ] [ | { begin | include | exclude } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
slot slot-number: Displays the ICMP statistics on the specified device. If the device is in an IRF, the slot-
number argument represents the member ID of the device; if the device is not in any IRF, the slot-number
argument represents the device ID.
If the switch does not support IRF, the slot-number argument must be 1.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use the display icmp statistics command to display ICMP statistics.
Related commands: display ip interface and reset ip statistics.
Examples
# Display ICMP statistics.
<Sysname> display icmp statistics
Input: bad formats 0 bad checksum 0
echo 5 destination unreachable 0
source quench 0 redirects 0
echo reply 10 parameter problem 0
timestamp 0 information request 0
mask requests 0 mask replies 0
To Next Page
Loading...
