HP A5120 EI Series

157
<Sysname> system-view
[Sysname] ipv6
ipv6 address
Syntax
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-address/prefix-length ]
View
Interface view
Default level
2: System level
Parameters
ipv6-address: Specifies the IPv6 address.
prefix-length: Specifies the prefix length of the IPv6 address, in the range 1 to 128.
Description
Use the ipv6 address command to configure an IPv6 global unicast address for an interface.
Use the undo ipv6 address command to remove the IPv6 address from the interface.
By default, no global unicast address is configured for an interface.
Except for the link-local address automatically obtained and the one generated through stateless
autoconfiguration, all IPv6 addresses will be removed from the interface if you carry out the undo ipv6
address command without any parameter specified.
Examples
# Set the global IPv6 unicast address of VLAN-interface 100 to 2001::1 with prefix length 64.
Method I:
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001::1/64
Method II:
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address 2001::1 64
ipv6 address anycast
Syntax
ipv6 address ipv6-address/prefix-length anycast
undo ipv6 address ipv6-address/prefix-length anycast
View
Interface view