HP A5120 EI Series User Manual

1
ARP configuration commands
arp check enable
Syntax
arp check enable
undo arp check enable
View
System view
Default level
2: System level
Parameters
None
Description
Use the arp check enable command to enable dynamic ARP entry check.
Use the undo arp check enable command to disable dynamic ARP entry check.
By default, dynamic ARP entry check is enabled.
Examples
# Enable ARP entry check.
<Sysname> system-view
[Sysname] arp check enable
arp max-learning-num
Syntax
arp max-learning-num number
undo arp max-learning-num
View
Ethernet interface view, VLAN interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
number: Specifies the maximum number of dynamic ARP entries that an interface can learn, in the range
0 to 1024.
Description
Use the arp max-learning-num command to configure the maximum number of dynamic ARP entries that
an interface can learn.

HP A5120 EI Series Specifications

General

Uplink Ports	4 x SFP
Stacking	No
Management	CLI, Web, SNMP
Routing Protocols	RIP, OSPF
Power Supply	AC
MAC Address Table Size	16K
Dimensions	440 x 430 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% non-condensing
Model	HP A5120-24G EI Switch (JG234A)
VLANs	4094