HP A5120 EI Series User Manual

179
reset udp ipv6 statistics
Syntax
reset udp ipv6 statistics
View
User view
Default level
2: System level
Parameters
None
Description
Use the reset udp ipv6 statistics command to clear the statistics of all IPv6 UDP packets.
You can use the display udp ipv6 statistics command to display the statistics of IPv6 UDP packets.
Examples
# Clear the statistics of all IPv6 UDP packets.
<Sysname> reset udp ipv6 statistics
tcp ipv6 timer fin-timeout
Syntax
tcp ipv6 timer fin-timeout wait-time
undo tcp ipv6 timer fin-timeout
View
System view
Default level
2: System level
Parameters
wait-time: Specifies the length of the finwait timer for IPv6 TCP connections in seconds, in the range 76 to
3600.
Description
Use the tcp ipv6 timer fin-timeout command to set the finwait timer for IPv6 TCP connections.
Use the undo tcp ipv6 timer fin-timeout command to restore the default.
By default, the length of the finwait timer is 675 seconds.
Examples
# Set the finwait timer length of IPv6 TCP connections to 800 seconds.
<Sysname> system-view
[Sysname] tcp ipv6 timer fin-timeout 800

HP A5120 EI Series Specifications

General

Uplink Ports	4 x SFP
Stacking	No
Management	CLI, Web, SNMP
Routing Protocols	RIP, OSPF
Power Supply	AC
MAC Address Table Size	16K
Dimensions	440 x 430 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% non-condensing
Model	HP A5120-24G EI Switch (JG234A)
VLANs	4094