HP A5120 EI Series User Manual

91
Description
Use the display dhcp-snooping trust command to display information about trusted ports.
Related commands: dhcp-snooping trust.
Examples
# Display information about trusted ports.
<Sysname> display dhcp-snooping trust
DHCP Snooping is enabled.
DHCP Snooping trust becomes active.
Interface Trusted
========================= ============
GigabitEthernet1/0/1 Trusted
The output shows that DHCP snooping is enabled, DHCP snooping trust is active, and port
GigabitEthernet 1/0/1 is trusted.
reset dhcp-snooping
Syntax
reset dhcp-snooping { all | ip ip-address }
View
User view
Default level
1: Monitor level
Parameters
all: Clears all DHCP snooping entries.
ip ip-address: Clears the DHCP snooping entries of the specified IP address.
Description
Use the reset dhcp-snooping command to clear DHCP snooping entries.
Related commands: display dhcp-snooping.
Examples
# Clear all DHCP snooping entries.
<Sysname> reset dhcp-snooping all
reset dhcp-snooping packet statistics
Syntax
reset dhcp-snooping packet statistics [ slot slot-number ]
View
User view
Default level
2: System level

HP A5120 EI Series Specifications

General

Uplink Ports	4 x SFP
Stacking	No
Management	CLI, Web, SNMP
Routing Protocols	RIP, OSPF
Power Supply	AC
MAC Address Table Size	16K
Dimensions	440 x 430 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% non-condensing
Model	HP A5120-24G EI Switch (JG234A)
VLANs	4094