HP A5120 EI Series

171
Examples
# Enable ND snooping for VLAN 1.
<Sysname> system-view
[Sysname] vlan 1
[Sysname-vlan1] ipv6 nd snooping enable
ipv6 nd snooping max-learning-num
Syntax
ipv6 nd snooping max-learning-num number
undo ipv6 nd snooping max-learning-num
View
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
number: Specifies the maximum number of ND snooping entries that can be learned by the interface, in
the range 0 to 4096.
Description
Use the ipv6 nd snooping max-learning-num command to configure the maximum number of ND
snooping entries that can be learned on the interface.
Use the undo ipv6 nd snooping max-learning-num command to restore the default.
By default, the number of ND snooping entries that an interface can learn is not limited.
Examples
# Set the maximum number of ND snooping entries that can be learned on Layer 2 Ethernet interface
GigabitEthernet 1/0/1 to 1000.
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] ipv6 nd snooping max-learning-num 1000
# Set the maximum number of ND snooping entries that can be learned on Layer 2 aggregate interface 1
to 1000.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] ipv6 nd snooping max-learning-num 1000
ipv6 neighbor
Syntax
ipv6 neighbor ipv6-address mac-address { vlan-id port-type port-number | interface interface-type
interface-number }
undo ipv6 neighbor ipv6-address interface-type interface-number