To Next Page

To Previous Page

• 8 GB

• 16 GB

For memory configurations see “Installing DIMMs” (page 47).

1. Power off the server (“Powering off the server” (page 94)).

2. Extend or remove the server from the rack (“Removing the server from the rack” (page 95) or

“Extending the server from the rack” (page 93)).

3. Remove the access panel (“Removing the access panel” (page 43)).

4. Remove the memory riser.

NOTE: You can access the memory riser boards without removing the airflow guides. Airflow

guides are only required for memory riser slots 2 and 3.

5. Remove the DIMM.

Removing and replacing DIMMs 113

Questions and Answers:

Need help?

Do you have a question about the HP Carrier-Grade rx2800 i2 Server DC and is the answer not in the manual?

HP Carrier-Grade rx2800 i2 Server DC Specifications

General

Form Factor	2U Rack
Product Type	Carrier-grade server
Memory Type	DDR3
Hard Drive Interface	SAS
Storage	Up to 8x 2.5-inch SAS HDDs/SSDs
Power Supply	Redundant Power Supplies
Operating System	HP-UX
Operating System Support	HP-UX
Processor	Intel Itanium Processor 9300 series
Memory	Up to 384 GB (24 DIMM slots)