EasyManuals Logo

HP Compaq 6005 Pro User Manual

HP Compaq 6005 Pro
155 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Wake the computer by pressing any key on the keyboard or pressing the power button. If the
system remains in suspend mode, shut down the computer by pressing and holding the power
button for at least four seconds then press the power button again to restart the computer. If the
system will not shut down, unplug the power cord, wait a few seconds, then plug it in again. The
computer will restart if it is set to automatic start after power loss in Computer Setup as soon as
power is restored. If it does not restart, press the power button to start the computer.
Reconfigure the computer after installing a non-plug and play expansion board or other option.
See
Solving Hardware Installation Problems on page 113 for instructions.
Be sure that all the needed device drivers have been installed. For example, if you are using a
printer, you need a driver for that model printer.
Remove all bootable media (CD or USB device) from the system before turning it on.
If you have installed an operating system other than the factory-installed operating system,
check to be sure that it is supported on the system.
If the system has multiple video sources and a single monitor, the monitor must be plugged into
the monitor connector on the source selected as the primary input. During boot, the other
monitor connectors are disabled and if the monitor is connected to these ports, the monitor will
not function. You can select which source will be the default input source in Computer Setup.
CAUTION: When the computer is plugged into an AC power source, there is always voltage applied
to the system board. You must disconnect the power cord from the power source before opening the
computer to prevent system board or component damage.
Helpful Hints
95

Table of Contents

Other manuals for HP Compaq 6005 Pro

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq 6005 Pro and is the answer not in the manual?

HP Compaq 6005 Pro Specifications

General IconGeneral
Processor cache2 MB
Processor cores2
Processor modelB26
Processor familyAMD Athlon II X2
Processor frequency3.2 GHz
Processor cache typeL2
Processor manufacturerAMD
Number of processors installed1
Operating system installedWindows 7 Professional
Compatible operating systemsFreeDOS
Operating system architecture32-bit
HDD speed7200 RPM
HDD interfaceSATA
Optical drive typeDVD Super Multi
Card reader integratedYes
Total storage capacity320 GB
Audio systemHD
Product typePC
Motherboard chipsetAMD 785G
Memory slots4x DIMM
Internal memory2 GB
Memory clock speed1333 MHz
Internal memory typeDDR3-SDRAM
Maximum internal memory- GB
Memory layout (slots x size)1 x 2 GB
Networking featuresGigabit Ethernet
Floppy drive installedNo
Compliance industry standardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Discrete graphics card modelAMD Radeon HD 4200
Display diagonal24 \
Display brightness300 cd/m²
Display resolution1920 x 1200 pixels
Native aspect ratio16:10
Viewing angle, horizontal160 °
USB 2.0 ports quantity6
Parallel ports quantity-
Firewire (IEEE 1394) ports0
Cabling technology10/100/1000Base-T(X)
Ethernet LAN data rates10, 100, 1000 Mbit/s
Chassis typeMicro Tower
Product colorBlack
Country of originChina
Power supply input voltage110 - 240 V
Power supply input frequency50 - 60 Hz
Weight and Dimensions IconWeight and Dimensions
Depth430 mm
Width176 mm
Height377 mm
Weight9300 g

Related product manuals