b. Press the tab on right side of the cage (2), and then swing the right side of the cage away
from the chassis to remove it (3).
NOTE: If the cage sticks and will not come loose, press down on the top of the panel near
the tab while pressing the tab.
Figure 6-37 Removing the I/O panel cage
11. Remove the heat sink (Heat sink on page 60).
12. Disconnect all cables connected to the system board, noting their location for reinstallation.
13. Remove the three remaining Torx T15 screws that secure the system board to the chassis (1).
System Board
65
To Next Page
Loading...
