Computer Setup
Hardware and Software Guide 13–3
Computer Setup Defaults
To return all settings in Computer Setup to the values that were
set at the factory:
1. Open Computer Setup by turning on or restarting the
notebook. Press
f10 while the “F10 = ROM Based Setup”
message is displayed in the lower-left corner of the screen.
❏ To change the language, press f2.
❏
To view navigation information, press f1.
2. Use the arrow keys to select File > Restore defaults.
3. Select the Restore Defaults check box.
4. To confirm the restoration, press
f10.
5. Select File > Save Changes and Exit, and then follow the
instructions on the screen.
When the computer restarts, the factory settings are restored, and
any identification information you may have entered is saved.
✎
Password- and security-related settings are not changed when
you reset the factory default settings.
To Next Page
Loading...
