Multimedia
Hardware and Software Guide 4–9
Installing Software
To install software included with the notebook on a disc:
1. Insert an appropriate optical drive into an external MultiBay
or MultiBay II. Refer to the “MultiBay II Optical Drive”
section in Chapter 5, “Drives.”
2. Connect the notebook to a reliable electrical outlet.
3. Close any open applications.
4. Insert a software disc into the optical drive.
❏ If autorun is enabled an installation wizard is displayed.
❏ If autorun is disabled, select Start > Run. Enter:
x:\setup.exe
(where x is your optical drive designation), and then
select OK.
5. When the installation wizard is displayed, follow the
installation instructions on the screen.
6. Restart the notebook if prompted.
✎
Repeat the installation procedure for all software you want
to install.
✎
WinDVD Creator has special drive requirements for proper
installation. To install WinDVD Creator, refer to the instructions
provided with the InterVideo WinDVD Creator disc.
To Next Page
Loading...
