HP Compaq NC4000

13–8 Hardware and Software Guide
Computer Setup
Device options ■ Enable/disable multiple standard
pointing devices at startup. (To set
the notebook to support only a single,
usually nonstandard, pointing device at
startup, select Disable.)
■ Select a parallel port mode: EPP
(Enhanced Parallel Port), standard,
bidirectional, or ECP (Enhanced
Capabilities Port).
■ Enable/disable USB legacy support for a
USB keyboard, mouse, and hubs. When
USB legacy support is enabled:
❐ A USB keyboard, mouse, and hubs
work even when a Windows
operating system is not loaded.
❐ The notebook starts from a
bootable hard drive, diskette drive
diskette, or CD-R, CD-RW, or DVD
inserted into a drive connected by
a USB connector to the notebook
or to an optional docking device.
■ Swap the functions of the fn key and left
ctrl key.
■ Enable/disable LAN Power Save Mode.
■ Enable/disable the fan to always be
on while the notebook is connected to
AC power.
■ Enable/disable Intel® SpeedStep.
■ Enable/disable LAN/WLAN switching.
■ Enable/disable Bluetooth and WLAN.
✎
Bluetooth and WLAN settings are
accessible only if the notebook is
equipped with a Bluetooth or WLAN
device.
Select To Do This