Maximum (85% Efficient PS)
Typical (idle; 85% Efficient PS)
1519 BTU/hr
239 BTU/hr
383 kg-cal/hr
60 kg-cal/hr
Power Supply
Operating Voltage Range
1
Rated Voltage Range
Rated Line Frequency
115V
90-264 VAC
100-240 VAC
50-60 Hz
230V
90-264 VAC
100-240 VAC
50-60 Hz
Power Output 365 W 365 W
Rated Input Current (maximum)
1
Standard PS
85% Efficient PS
6A @ 100 VAC
5A @ 100VAC
3A @ 200 VAC
2.5A @ 200VAC
1
This system utilizes an active power factor corrected power supply. This allows the system to pass the CE mark requirements
for use in the countries of the European Union. The active power factor corrected power supply also has the added benefit of
not requiring an input voltage range select switch.
SFF Specifications
Table F-2 Specifications
Desktop Dimensions (in the desktop position)
Height
Width
Depth
3.95 in
13.3 in
14.9 in
10.0 cm
33.8 cm
37.8 cm
Approximate Weight 19 lb 8.6 kg
Weight Supported (maximum distributed load in desktop
position)
77 lb 35 kg
Temperature Range
Operating
Nonoperating
50° to 95°F
-22° to 140°F
10° to 35°C
-30° to 60°C
NOTE: Operating temperature is derated 1.0° C per 300 m (1000 ft) to 3000 m (10,000 ft) above sea level; no direct
sustained sunlight. Maximum rate of change is 10° C/Hr. The upper limit may be limited by the type and number of
options installed.
Relative Humidity (noncondensing)
Operating
Nonoperating (38.7°C max wet bulb)
10-90%
5-95%
10-90%
5-95%
Maximum Altitude (unpressurized)
Operating
Nonoperating
10,000 ft
30,000 ft
3048 m
9144 m
Heat Dissipation
Maximum (standard PS)
1260 BTU/hr 318 kg-cal/hr
Table F-1 Specifications (continued)
280 Appendix F Specifications
To Next Page
Loading...
