116 HP ProLiant DL360 Generation 4 Server Reference and Troubleshooting Guide
on the front of the drive and look inside to see that the drive leader is
connected to the buckling link-hook.
2. Be sure the diskette is not write protected. If it is, use another diskette or
remove the write protection.
3. Be sure you are attempting to write to the proper drive by checking the drive
letter in the path statement.
4. Be sure enough space is available on the diskette.
DLT Drive Problems
List of Problems:
Server cannot write to tape.........................................................................................................116
DLT drive failure occurs ............................................................................................................117
DLT drive does not read tape .....................................................................................................117
Server cannot find the DLT drive...............................................................................................117
An error occurs during backup, but the backup is completed ....................................................118
Server cannot write to tape
Action:
• If the drive cleaning light is on, clean the drive.
NOTE: DLT cleaning cartridges are good for only 20 uses. If the
cleaning cartridge is near that limit and the drive cleaning light is still on
after running the cleaning cartridge, use a new cleaning tape to clean
the drive.
• If the tape is write protected, remove the write protection. If the tape still
does not work, insert another tape into the drive to see if the original tape is
faulty.
• Refer to the tape drive documentation to be sure the type of tape being used
is supported by the drive.
• Check each tape cartridge that has been used in the drive to verify its
condition and inspect its tape leader to verify it is not damaged and is in the
correct position. After you locate any bad cartridges, dispose of them. A
working tape drive may drop its leader when using bad cartridges, indicating
that they need replacing. If bad cartridges are found, you will need to inspect
the DLT drives leader assembly.
− To examine the cartridge take-up leader, tilt the cartridge receiver door
To Next Page
Loading...
Need help?
General
