HP DL360 Reference And Troubleshooting Guide

48 HP ProLiant DL360 Generation 4 Server Reference and Troubleshooting Guide
After installing DIMMs, use RBSU to configure the system for online spare
memory support ("Configuring Online Spare Memory" on page 69
).
Installing DIMMs
1. Power down the server ("Powering Down the Server" on page 25).
2. Extend the server from the rack, if applicable ("Extending the Server from
the Rack" on page 26
).
3. Remove the access panel ("Removing the Access Panel" on page 27
).
4. If installed, remove the half-length expansion board ("Expansion Board" on
page 57
).
5. Open the DIMM slot latches.
6. Install the DIMM.
7. If removed, reinstall the half-length expansion board ("Installing an
Expansion Board" on page 58
).
8. Install the access panel ("Installing the Access Panel" on page 28).
9. If you are installing DIMMs in an online spare configuration, use RBSU to
configure this feature ("Configuring Online Spare Memory" on page 69).

HP DL360 Specifications

General

Processor Sockets	2
CPU	Intel Xeon Scalable
Memory	Up to 3TB DDR4
Form Factor	1U Rack
Power Supply	Redundant Power Supplies, various wattage options
Network Controller	Embedded 1Gb or 10Gb Ethernet
RAID Support	Smart Array RAID
Operating System Support	Windows Server, Linux, VMware
Storage	Up to 10 SFF SAS/SATA/NVMe drives or 4 LFF SAS/SATA drives