Table 5-3 Computer Setup—Advanced (for advanced users) (continued)
Option Heading
Virtualization Technology (VTx) (Intel only)
Controls the virtualization features of the processor. Changing this setting requires turning the computer
o and then back on. Default is disabled.
Virtualization Technology for Directed I/O (VTd) (Intel only)
Controls virtualization DMA remapping features of the chipset. Changing this setting requires turning the
computer o and then back on. Default is disabled.
M.2 SSD
Lets you disable the M.2 solid-state drive slot. Default is enabled.
M.2 WLAN/BT
Lets you disable the wireless module slot. Default is enabled.
Allow PCIe/PCI SERR# Interrupt (enable/disable)
Allows PCI devices to report PCI/PCIe System Error signals, such as address parity errors, data parity
errors, and critical errors other than parity. Default is enabled.
Power Button Override (disable/4 sec/15 sec)
Lets you disable or enable and select the number of seconds you have to hold down the power button for
it to force the system to power o. Default is ‘4 sec’.
USB Type-C Connector System Software Interface (UCSI) (enable/disable)
Default is enabled.
Built-In Device Options Embedded LAN Controller
Select to show the device in the operating system. Default is enabled.
Wake On LAN
Lets you either disable the Wake On LAN feature, or congure where the computer boots, including the
network or hard drive. Default is Boot to Network.
Allow No Panel conguration
When enabled, POST blink and beep codes and error messages are not generated. Default is disabled.
Video memory size
Use this option to manage graphics memory allocation. The value you choose is allocated permanently to
graphics and is unavailable to the operating system.
Integrated Camera
Clear to disable the integrated camera. Default is enabled.
Audio Device
Select to show the device in the operating system. Default is enabled.
Microphone
Clear to disable the microphone. This does not aect devices plugged into audio jacks. Default is enabled.
Internal Speakers (does not aect external speakers)
Clear to disable the chassis speaker or speakers. This function is applicable to normal audio playback in
the operating system and does not aect the error or warning beeps during POST. Default is enabled.
Headphone Output
Clear to disable the headphone jack. Default is enabled.
66 Chapter 5 Computer Setup (F10) Utility
To Next Page
Loading...
