Using a nano SIM card (select products only)
Select products support a wireless subscriber identity module (SIM) card.
Inserting a nano SIM card
CAUTION: To prevent damage to the connectors, use minimal force when inserting a nano SIM card.
CAUTION: To prevent damage to a SIM card or a computer, do not change the size of a SIM card by cutting or
sanding the card.
To insert a nano SIM card:
1. Position the computer display-side up on a at surface.
2. Insert the removal tool or a small straightened paper clip (1) into the card tray access hole.
3. Press the tool or clip in gently until the card tray is ejected.
4. Remove the tray (2) from the computer and insert the card (3).
5. Replace the tray in the computer. Press in gently on the tray (4) until it is rmly seated.
To insert a nano SIM card, reverse the steps.
Using a nano SIM card (select products only) 17
To Next Page
Loading...
Need help?
General