Turn off the equipment using the branch circuit breakers in either of the following cases:
● During a thunderstorm
● During a power failure
Operate the equipment only within the specified ranges of operating temperature and humidity. See the
Sit
e Preparation Guide at: .
●
http://www.hp.com/go/jetfusion3D5200/manuals/
● http://www.hp.com/go/jetfusion3D5210/manuals/
● http://www.hp.com/go/jetfusion3D5210pro/manuals/
The printer, build unit, and processing station should always be kept in the same environmental
conditions.
The print-production area in which the equipment is installed should be free from liquid spillage and
en
vironmental condensation.
Ensure that there is no condensation inside the equipment before turning it on.
Users and operators must be trained for explosive atmospheres and associated hazards during
cleaning and maintenance operations, according to local laws and company requirements.
Take special care with zones marked with warning labels.
Use HP-certified and HP-branded material and agents only. Do not use unauthorized third-party material
or agents.
Use HP-certified external tanks only. The use of third-party external tanks can cause safety risks,
material leakages, and malfunctions in the processing station; and may affect your system warranty.
In case of unexpected malfunction, anomaly, ESD (ElectroStatic Discharges), or electromagnetic
interference, press the emergency stop button and disconnect the equipment. If the problem persists,
contact your support representative.
Do not repair or replace any part of the equipment or attempt any servicing unless specifically
recommended in the user-maintenance instructions or in published user-repair instructions that you
understand and have the skills to carry out.
Do not attempt to repair, disassemble, or modify the equipment by yourself; and do not use any part
other than original HP spare parts.
To repair or reinstall the equipment, please contact your nearest service authorized provider; otherwise,
you may experience electric shock, fire, problems with the product, or injury.
Final parts/builds
The customer assumes all risk relating to or arising from the 3D printed parts.
The customer is solely responsible for the evaluation of and determination of the suitability and
compliance with applicable r
egulations of the products and/or 3D printed parts for any use, especially
for uses (including but not limited to medical/dental, food contact, automotive, heavy industry, and
consumer products) that are regulated by US, EU, and other applicable governments.
Final parts/builds 5
To Next Page
Loading...