4. The final position of the forklift foot should be as shown below.
5. Now you can tighten the screws attaching the U-shaped tube.
6. Count the number of sheet-metal parts you have used on the right, make sure you have used the
same number of parts on the left, and tighten the screw on the left.
7. Check that the natural cooling unit can be moved over the build unit.
Extracting the build to the natural cooling unit
Extracting the build from the build unit frees the build unit to be used for another job.
NOTE: The natural cooling unit is an accessory. See Accessories on page 25.
1. Remove the build unit from the printer.
2. Use an explosion-protected vacuum cleaner to remove any material from the overflow trays.
3. Insert the build unit in the processing station, go to the processing station’s front panel, and tap
Build unit >
Cooling unit.
84 Chapter 9 Unpack the build
To Next Page
Loading...