When printing with TPU, after the job has been printed successfully, the build unit will be maintained
at optimal temperature for manual unpacking for 4 hours. This process is canceled by removing the
build unit from the printer, after which it cannot be resumed. After disconnecting the build unit from the
printer, manual unpacking must be finished in the time indicated on the front panel (2 hours for a full
build chamber).
Check status remotely
You can check the job status from the Command Center.
See HP SmartStream 3D Command Center on page 31
Possible errors while printing
If one of these errors occurs, the printer cancels the job immediately.
● Out of agent
● Out of cleaning roll
● Printhead error
● Broken lamp
● Crash during printing
● Power cut
IMPORTANT: Wait until the printer tells you it is safe to remove the build unit.
Proceed with the cooling process and unpacking if relevant. If no parts have been printed, the build unit
should be cleaned and loaded be
fore using it again.
Print modes
In the HP SmartStream 3D Build Manager, you can choose the balanced or the fast print mode from the
print profile drop-down menu.
● Balanced mode delivers balanced properties.
● Fast mode maximizes speed for any job.
76 Chapter 8 Print
To Next Page
Loading...