3. Turn the service switch to the on position.
4. Perform a visual check of the station.
5. Wait for the front panel to indicate that the station is ready. This can take several minutes. When
initialization is complete, the front panel displays a Ready message. If a system error message is
displayed, see System errors on page 356.
Turn the processing station on and off
After you have turned on the processing station for the first time, you can use any of these methods to
turn it on and o
ff.
The processing station has two power-off levels. Level 1 is recommended if you intend to use it again
soon. Otherwise, you are recommended to use level 2, which is complete shutdown.
Table 4-2 Turn the processing station on and off
Level Turn off Turn on
1: Standby (5 V) Front-panel power button off Front-panel power button on
2: All processing-
s
tation systems off
1. Front-panel power button off
2. Red main power switch off
1. Red main power switch on
2. Front-panel power button on
Circuit-breaker labels
You may see these labels on your circuit breakers.
Table 4-3 Circuit-breaker labels
Label Description
Main power
Turn the processing station on and off 39
To Next Page
Loading...